K2 Red Silicon +350°C 21g

High-quality silicone. Adapts perfectly to the surfaces being sealed. Resistant to high temperatures up to 350°C. Meets the requirements of vehicle manufacturers (O.E.M. – Original Equipment Manufacturer). Replaces traditional gaskets made of cork, paper, felt, asbestos, or rubber. Thanks to its "SENSOR SAFE" formula, it is safe for use with lambda sensors in modern vehicles equipped with electronic fuel injection. Resistant to oils, greases, coolants, etc. Suitable for all vehicle makes and models; can be used to seal components such as valve covers, thermostat gaskets, oil pans, camshaft covers, water pumps, rear axle differential covers, and many other parts requiring a tight seal and resistance to high temperatures.

DIRECTIONS FOR USE:

The surface must be dry and free from dust, dirt, grease, and any remnants of old gasket material.
Apply a small amount of silicone to the surface. Remove any excess using, for example, a knife dipped in soapy water.
The sealant begins to dry after 5 minutes and is dry to the touch after 1 hour. It cures completely within 24 hours.
Excess cured silicone can be removed using a sharp tool.
Replace the cap on the tube after each use.